Great! Oct 01, 2016

Had this boiler for 2 winters now in MA. First winter was hard. This last one less so. Great product. Made is USA. Cast iron. Will last forever my plumber tells me. Still 84% efficient. Doesn't need yearly maintenance like the higher efficient junk out there. That high efficient junk also requires a power vent that is super loud. Consider that too in your purchase. This Burnham is very quiet. No power vent. I use an old school dial thermostat and set it at 67. When I get my heating bill... more

Cheap And Efficient, Good Value Oct 06, 2016

The unit looks nice and works very well, easy enough to retrofit to an existing 20 yr old duct work.

Excellent Service Dec 19, 2016

At this point I cannot review performance as we have not yet used the heated floor. I will say that I am impressed with the cost of this product from eComfort. We surveyed several options for purchasing the DitraHeat and eComfort was significantly less than the other options. I was concerned about delivery time and made a call to customer service with my inquiry. They were very helpful and promised a return call the next day to advise on the shipping status of my order. That call was made... more

Great Product Oct 02, 2016

I have extensive building trade skills so installing the AC unit was quite simple for me to tackle myself. I had to have a branch 220v electrical panel added to service the unit. The only problem I had was finding a HVAC contractor to test the unit for leaks prior to firing it up. Since most licensed HVAC contractors don't want to touch so small a job or they don't want the liability of signing off on the leak test if they did not install the unit themselves. I can understand that, but... more

Warmwire Heated Floor Mar 30, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more